Long Kang glass fiber reinforced plastic anti-corrosion construction program 

 1, Introduction to construction 



 1, ready to work: 

 (1) pre-construction to ensure that the concrete floor to completely dry the basis of formation, and then to base oil brushing. 

 ② prepare construction required FRP raw materials and construction equipment. 

 2, the specific construction procedure for the three fabrics and five oil primer again to be solidified and then brush again, epoxy, glass cloth layer, painted again, glass cloth layer, painted again, glass cloth layer and finally painted ring oxygen will cover can be. 

 3, finished Protection: pool irrigation class, the construction environment is not conducive to the curing of epoxy molding, it is necessary to require 48 hours of curing time, can be used until completely cured. 

 Two, the construction plan is as follows in the number of 

 1, the professional anti-corrosion construction workers 

 2, one of foreman (construction tools to bring your own) 

 Third, the construction quality requirements 

 1, according to the actual on-site to do a good job in all aspects of construction work, mutual inspection and special inspection in order to meet quality requirements. 

 2, during the construction period and construction personnel to be responsible for their own work, continuously improve the quality of work. 

 Fourth, the fire safety measures 

 Raw materials used in construction for flammable substances, all construction workers to enter the scene are not smoking, No smoking. 

 2, the construction workers to enter the site to comply with the rules and regulations, and obey the foreman arrangements. 

 During brushing enamel site must have a fan to send a new wind to keep the pool fresh air or wear gas masks in order to better construction. 

 Glass fiber reinforced plastic anti-corrosion construction process 

 First, the operating conditions 

 Construction ambient temperature to 5-25 ° C is appropriate, relative humidity less than 8% fiberglass construction strict check whether the formation of ground-based construction because construction ring actually in the basement so necessary in the ground is not completely dry with ventilation and low-voltage lighting. 

 Second, the concrete base surface requirements 

 The concrete surface should be solid, dense, smooth, there should be from the sand, from the shell, crack phenomenon. Pool the inner wall of the foundation concrete time wiping the yin and yang should be made of beveled or rounded corners, angle in order to achieve the purpose of convenience of construction. 

 Third, the process operation 

 A preparation resistant epoxy container should be kept clean, dry, no oil. 

 2, the preparation of rubber each preparation should be based on engineering capacity and operating number may be used with the distribution. 

 3, epoxy resin prepared by alcohol and T31 of the degree of curing procedures are as follows: take a quantitative epoxy resin in the container, then add the T31 curing agent stir evenly with a good run out within 30 minutes. 

 4, brushing layers of glass cloth for three times, first brushing finished second over the process, followed by construction to the topcoat finished. Completely cured topcoat, you can use. 

 Fourth, the quality requirements 

 An epoxy anti-corrosion construction after surface of uniform color, seamless coated bubbles and other phenomena. 

 2, corrosion-resistant surface smooth, and enhanced layer of concave and convex part of the height difference should not exceed 20% of wall thickness. 

 Fifth, the finished product protection 

 1, does not allow the coating on the strength check, so as not to adversely affect the test hole to finished product. But with the acid and alkali material drops sprinkled on the surface for corrosion resistance testing. 

 2, to prevent welding sparks out to be located in the finished surface, if contact liner or iron as protection. 

 Shelf life: the shelf life of the construction project quality are of one year.